When I set a preset on the tablet, the meter does not stop and pumps more fuel to the customer than intended.

• Related Articles

• When I go to the meter and tap on Start or place the meter in the run position, the numbers do not reset and fuel is not flowing from the meter.

  - First thing to check is can the meter print to the printer.  If the meter cannot print, it will not pump fuel.  - Check printing directly from the meter by printing a diagnostic page.  - If meter is printing fine, try to setup your delivery and ...

• While pumping fuel, I was able to finish the delivery, but when I went to the tablet, it still shows the delivery flow active and seems to be stuck.

  - Perform a manual delivery to finish the action on the tablet.  - If the problem persists, troubleshoot connectivity to the Parani Bluetooth Antenna (above)   

• Can I take the tablet from one truck and use it in another truck?

  - You can swap tablets into a different truck.  - In order to do this, you must go into Bluetooth Settings in the tablet once you are in the truck you will be driving.  - In Delivery Droid > Bluetooth Settings you must pair with the Printer and the ...

• The meter does not seem to be communicating with the tablet. No totalizer reading and will not connect in Delivery Screen.

  - Start by turning ignition off and on.  Then try again.  - Check to make sure that the Parani Bluetooth antenna is flashing three times in a row.  If not the issue is with the Bluetooth antenna.  - Check all connections starting from the lappad ...

• I have tried other stuff to get things working properly and I am having no luck.

  - Turn the ignition off and then on again.  - Reseat or restart the printer.  - Reboot the tablet and log back in.  - Verify that all connections are seated tightly for the Bluetooth adapter and lappad adapter in the cabling, disconnect and reconnect ...