When I go to the meter and tap on Start or place the meter in the run position, the numbers do not reset and fuel is not flowing from the meter.

• Related Articles

• When I set a preset on the tablet, the meter does not stop and pumps more fuel to the customer than intended.

  - Presets need to be confirmed at the meter prior to pumping in order to ensure proper amount of fuel is delivered.  - Before you pump, follow the recommended manufacturer procedures for setting a preset (based on which register you are using, LCR, ...

• When I press Start Pump in the Delivery Screen, it changes color for a few moments and then returns to orange as if I never pressed Start Pump.

  - Zebra printers need to be turned off and back on and reseated on the doc if there is an issue with Start Pump.  - If you have a different kind of printer, try turning the printer off and back on.  - Check to make sure the printer is paired in ...

• The meter does not seem to be communicating with the tablet. No totalizer reading and will not connect in Delivery Screen.

  - Start by turning ignition off and on.  Then try again.  - Check to make sure that the Parani Bluetooth antenna is flashing three times in a row.  If not the issue is with the Bluetooth antenna.  - Check all connections starting from the lappad ...

• Can I take the tablet from one truck and use it in another truck?

  - You can swap tablets into a different truck.  - In order to do this, you must go into Bluetooth Settings in the tablet once you are in the truck you will be driving.  - In Delivery Droid > Bluetooth Settings you must pair with the Printer and the ...

• When I go to Bluetooth Settings on the tablet, I am not able to see any Bluetooth devices even after scanning.

  - Verify that the ignition is turned on and that the Parani Bluetooth adapter is plugged in and blinking.  Check the ON -> Off switch on the device, and turn ON, if it is not flashing.  - The Bluetooth adapter must be in always pairing mode.  The way ...