Can I take the tablet from one truck and use it in another truck?
- You can swap tablets into a different truck.
- In order to do this, you must go into Bluetooth Settings in the tablet once you are in the truck you will be driving.
- In Delivery Droid > Bluetooth Settings you must pair with the Printer and the Meter from the truck you will be using.
- Then in Bluetooth Settings you must choose the correct paired devices for both Meter and Printer.
Related Articles
When I go to Bluetooth Settings on the tablet, I am not able to see any Bluetooth devices even after scanning.
- Verify that the ignition is turned on and that the Parani Bluetooth adapter is plugged in and blinking. Check the ON -> Off switch on the device, and turn ON, if it is not flashing. - The Bluetooth adapter must be in always pairing mode. The way ...
When I set a preset on the tablet, the meter does not stop and pumps more fuel to the customer than intended.
- Presets need to be confirmed at the meter prior to pumping in order to ensure proper amount of fuel is delivered. - Before you pump, follow the recommended manufacturer procedures for setting a preset (based on which register you are using, LCR, ...
While pumping fuel, I was able to finish the delivery, but when I went to the tablet, it still shows the delivery flow active and seems to be stuck.
- Perform a manual delivery to finish the action on the tablet. - If the problem persists, troubleshoot connectivity to the Parani Bluetooth Antenna (above)
The meter does not seem to be communicating with the tablet. No totalizer reading and will not connect in Delivery Screen.
- Start by turning ignition off and on. Then try again. - Check to make sure that the Parani Bluetooth antenna is flashing three times in a row. If not the issue is with the Bluetooth antenna. - Check all connections starting from the lappad ...
I have tried other stuff to get things working properly and I am having no luck.
- Turn the ignition off and then on again. - Reseat or restart the printer. - Reboot the tablet and log back in. - Verify that all connections are seated tightly for the Bluetooth adapter and lappad adapter in the cabling, disconnect and reconnect ...